Gledhill StainlessLite Indirect Solar Hot Water Cylinders are unvented mains pressurised hot water cylinders supplied with a high performance solar coil.
Made from Duplex Stainless Steel, these Indirect Solar Cylinders are designed to be heated from a conventional gas boiler or oil boiler
This Gledhill StainlessLite Cylinder has a 20% faster recovery rate than a hot water cylinder with a plain tube heat exchanger. Furthermore, they have the
Fastest Reheat Times ,
Lowest Heat Loss , and are the
Lightest cylinders on the market today.
This Gledhill StainlessLite Indirect Solar Cylinder includes:
Immersion Heater Full installation and maintenance instructions Temperature and pressure relief valve Inlet control set Benchmark Log Book 2 Port Zone Valve Wiring Centre Dual Thermostat 15mm / 22mm Tundish Expansion Vessel Wall Mounting Bracket Expansion Vessel Hose
Choosing The Correct Sized Cylinder
Max Hot Water Demand Max Number of Bedrooms (Bedspaces)Cylinder Required (Litres)
1 Shower Room
Bedsit (0)
90
1 Bathroom
2 (2)
120
1 Bathroom
4 (3)
150
1 Bathroom / Separate Shower Room
6 (4)
150
1 Bathroom / 2 Separate Shower Rooms or 2 Bathrooms
7 (5)
210
2 Bathrooms / Separate Shower Room
7 (5)
250
2 Bathrooms / 2 Separate Shower Rooms
7 (5)
300
Where used with solar it is important to match the dedicated solar volume with
the property specification to achieve compliance with Building Regulations.
Gledhill StainlessLite Indirect Solar Cylinder Specification
SOL300I
Empty Weight (kg) 46
Full Weight (kg) 346
Capacity (Litres) 300
Pressure Regulator (Bar) 2.25
Expansion Vessel Size (Litres) 40
Height (mm) 2020
Diameter (mm) 550
Primary Coil Rating (kW) 20.5
Solar Coil Rating (kW) 19
Recovery Time after 70% Draw Off (min) 20
Standing Losses (kWhr / 24 Hours) 1.93
Dedicated Solar Volume (Litres) 100
Designers should allow a footprint of 650mm x 650mm and sufficient height above for plumbing of the hot draw off
Gledhill StainlessLite Indirect Solar Cylinder Further Information
WATER SUPPLY - Best performance achieved above 1.5 Bar dynamic pressureFLOW RATES - Up to 50 Litres Per Minute can be achieved with adequate supplyBOILER COMPATIBILITY - Gas, Oil and Electirc Boilers are suitable. Solid Fuel Boilers must not be usedFIXING - Designed to be fixed verticallySAFETY FEATURES - High limit thermal cut-out operates at 85°C wired in series with two port motorised valveTHERMAL INSULATION - CFC/HCFC free fire retardant polyurethane foam with an ozone depletion potential of zero (ODP ZERO) and a global warning potential (GWP) of 1CASING - Plastic coated corrosion proofed steel
