This Boiler Unit houses a 9kW Electric Boiler + 180 Litre SOLAR Cylinder
The Fusion Combi Solar Unit is a new `plug-in and play’ Solar Combination Unit. Based around the proven technology of our Fusion E10 Combination Unit, this product includes a solar pump station and unvented Solar hot water cylinder within a single unit.
The Solar Combination Unit increases the SAP rating of the property as it reduces the carbon emission profile. It is an ideal product for new build homes and greatly assists local authorities who are increasingly requesting a significant proportion of renewable energy as a requirement for planning permission.
Feature List
This Fusion Solar Combination Unit is completely Pre-plumbed and pre-wired the following equipment :-
- Fusion Slimline Electric Boiler 9kW
- 180 Litre Direct, Un-Vented, Solar Cylinder
- Pre-wired Programmer and Cylinder Thermostat
- Pre-Plumbed, including Magnetic Filter and Isolation Valves
- Pre-fitted pump station
- Intelligent Solar Management System
- External Plumbing kit complete with Tundishes and Control valve for the incoming water main connection
Economy 10 Tariff
When used with the Economy 10 tariff, provides a very cost effective a alternative to electric storage heating, oil, solid fuel or LPG systems. It is the perfect solution for properties with no access to mains gas, homes which have gas restrictions and brown field sites. Not only is the Solar Combi the ideal choice for conventional wet central heating but is also suited to under-floor heating systems.
Boiler Further Information
Boiler Dimensional Diagram
Boiler & Solar Cylinder Unit Technical Table
| |
Units |
Boiler |
Cylinder |
| Heating Output |
Btu |
30717 |
|
| Electricity Supply |
230/240V 1ph 50 Hz |
|
| Load/Current |
Amp |
39.1 |
|
| Protection Required |
Amp |
45 |
|
| CH Max Temp Setting Factory Set |
°C |
85 |
|
| CH Min Temp Setting |
°C |
40 |
|
| CH Overheat Protection |
°C |
100 |
|
| Pump Included |
Yes |
|
| Recommended Pump Settings |
Set to Max |
|
| CH Flow & Return Pipes |
mm |
22 |
|
| Domestic & Primary Connections |
mm |
|
22 |
| Min Water Pressure |
Bar |
1.0 |
3.0 |
| Max Water Pressure |
Bar |
3.0 |
7.0 |
| Expansion Vessels |
Litre |
8.0 |
12.0 |
| Immersion Heater |
kW |
|
3.0 |
| Unit Dimensions |
mm |
1620(h) x 574(w) x 750(d) |
Please note - before purchasing any electric appliance we advise you to contact a qualified electrician, who will ensure you have adequate surplus electric supply to run this appliance. Once this product has been opened, a charge may apply if you return this item. It is a legal requirement that all electrical appliances are sent away for testing and repackaging before they can be resold.
The following link contains further information about this product
