This technologically advanced, versatile mains pressure water heater is ideal for localised use. The Europrisma can be used where hot water is required but where it is not convenient to enlarge the existing central hot water system or where there is no central system at all. Examples of such situations are small industrial units, warehouses, dentists' and doctors' surgeries, cafés, and certain residential situations, e.g. additional bathrooms, loft conversions, etc.
Water Heater Features
- Unvented cold water feed : see guide below
- Extra thick steel-plated tank, pressure tested and double coated vitreous enamelled
- Large magnesium anode
- CFC free polyurethane thermal insulation
- Regulation thermostat equipped with safety thermostat
- External temperature control
- Heating indicator light
- Front access for ease of maintenance
- Simple installation
Technical Data Table
| Capacity (Litres) |
30 |
| Voltage (V) |
240 Single Phase |
| Power (kW) |
3 |
| Immersion Heater Reheat Time (ΔT - 50°C) (min) |
58 |
| Maximum Temperature (°C) |
75 |
| Heat Loss 60°C (kWh/24h) |
0,9 |
| Installation Type |
oversink |
Dimensions
| A (mm) |
440 |
| B (mm) |
365 |
| C (mm) |
440 |
| D (mm) |
110 |
Typical Application (one of the following)
Medium Usage 4/5 basins or 2 sinks
Heavy Usage 1/2 basins or 1 Sink
Heavy Usage 2/3 basins or 1 Sink
|
Installation Using an Expansion Kit
The Europrisma 30 litre capacity unit has to be installed using an expansion kit, therefore it is necessary to use an expansion vessel and non-return valve (Kit A). If the mains water pressure may exceed 3.5 bar a pressure reducing valve (Kit B) should also be installed. The discharge from relief valves must be made in a safe and conspicuous manner; therefore a tundish (Kit C) is available for 10 and 15 litre units if required.
Expansion Kits (see product options tab to add to your order)
